Home . . About Accelerator . . Dealers . . Model Listing . . Instructions . . Contact us . . Site-map . . Videos

Accelerator Industries Instructions for catcher mounting on
Billy Goat 33 inch walk behind mower.
What you need to get started:
- Drill with 5/16 bit
- a clamp for holding position
Put the bracket in place as shown in the picture on the left. Clamp the bracket down, drill 2 holes through the bracket and the mower deck. Attach the bracket with the enclosed stainless steel bolts and nylock nuts.
The picture on the left shows a bracket side view when properly mounted. Note that the edge of the bracket is flush with the edge of the mower deck. Attach the catcher into the bracket by putting the stainless pin through the hole in the bracket and dropping the hook over the upper edge of the bracket.

IMPORTANT SAFETY NOTE:

IF YOU ARE GOING TO USE THE MOWER WITHOUT THE CATCHER INSTALLED, YOU MUST FIRST REMOVE THE BRACKET AND REATTACH THE DEFLECTOR SHIELD.

-- HEAVY LIFTING --

If the catcher becomes too full for you to carry, remove the door and empty some of the debris using a hoe or rake. DON’T OVERFILL ESPECIALLY WITH WET GRASS. The catcher can be quite heavy when it is full. While the catcher can take the heavy load, your body may not be able to. USE COMMON SENSE.

Warning label. Read before using catcher.
Failure to follow these instructions may result in serious injury
Never use mower without catcher or original grass deflector fully installed.
Never operate catcher without door shut and secured.
Always use eye protection when operating lawn mower.
Keep others away from the mowing area.
Do not use if you cannot safely lift heavy loads. Use proper lifting techniques.
Make sure engine is off and blade has stopped rotating before removing or installing catcher.
Use caution when mowing on slopes- the fuller and heavier the catcher is the more likely the mower is to tip over or slip.
Follow all safety instructions provided with the lawn mower.
Don’t use this catcher if it is cracked or damaged.
Don’t put your hands inside the catcher. Cuts or abrasions may result.

info@acceleratorindustries.com . . . . 1-800-984-9410

Home . . About Accelerator . . Dealers . . Model Listing . . Instructions . . Contact us . . Site-map . . Videos


Copyright- Accelerator Industries® Last revised: March 3, 2004