Accelerator Type 2A Grass Catcher Installation Video
Step by step instructions for installing the Accelerator Type 2A grass catcher.
Watch VideoTools Needed
- Safety glasses
- gloves
- ½” ratchet drive
- ½” open end wrench
- drill with sharp 5 / 16” bit
- hammer
- center punch
- two C-clamps
- pen
Each catcher comes with mounting instructions specific to that catcher. All catchers have a general information sheet that provides catcher care direction and basic instructions. If your catcher comes with a bracket in the box, then you will also receive specific bracket installation instructions.
It is your responsibility to read the warnings below and follow the provided instructions.
Lip Bracket Insallation (Type 2A)
If necessary, remove the deflector shield assembly to provide room to mount the catcher.
-
Step 1:
Place the catcher and the bracket together on the deck
-
Step 2:
When you have the catcher intake aligned with the mower discharge, mark the bracket placement on the deck. Clamp the bracket in place on the deck, and drill two 5 / 16” holes through the bracket and the deck
-
Step 3:
Insert the hardware and tighten it
Operator's Manual
Operator's Manual
Please read the operator's manual carefully before installing your catcher.